Filter
Top Products
Chapter 5 339
Language Reference
SENSe Subsystem
Radio Standards Commands
Radio Carrier Hopping
[:SENSe]:RADio:CARRier:HOP OFF|ON|0|1
[:SENSe]:RADio:CARRier:HOP?
Turns the carrier hopping mode on and off.
Factory Preset
and *RST: OFF
Remarks: Global to the current mode.
You must be in the EDGE(w/GSM), GSM mode to use
this command. Use INSTrument:SELect to set the
mode.
History: Version A.03.00 or later
Front Panel
Access:
Mode Setup, Radio, Carrier
Radio Carrier Multiple
[:SENSe]:RADio:CARRier:NUMBer SINGle|MULTiple
[:SENSe]:RADio:CARRier:NUMBer?
Select if single or multiple carriers are present on the output of the base
station under test. This enables/disables a software filter for the rho
and code domain power measurements.
Factory Preset
and *RST: SINGle
Remarks: You must be in the , iDEN mode to use this command.
Use INSTrument:SELect to set the mode.
Front Panel
Access:
Mode Setup, Demod, RF Carrier
Radio Carrier Burst
[:SENSe]:RADio:CARRier[:TYPE] BURSt|CONTinuous
[:SENSe]:RADio:CARRier[:TYPE]?
Select the type of RF carrier on the device to be tested.
Factory Preset
and *RST: BURSt
Remarks: You must be in the EDGE(w/GSM), GSM mode to use