Filter
Top Products
Chapter 5 327
Language Reference
SENSe Subsystem
Channel Power—Data Points
[:SENSe]:CHPower:POINts <integer>
[:SENSe]:CHPower:POINts?
Set the number of data points that will be used. Changing this will
change the time record length and resolution BW that are used.
Factory Preset
and *RST: 512
Range: 64 to 32768, in a 2
n
sequence
Remarks: You must be in the cdmaOne, cdma2000, W-CDMA
(3GPP), W-CDMA (Trial & Arib), or Basic mode to use
this command. Use INSTrument:SELect to set the
mode.
Channel Power—Data Points Auto
[:SENSe]:CHPower:POINts:AUTO OFF|ON|0|1
[:SENSe]:CHPower:POINts:AUTO?
Select auto or manual control of the data points. This is an advanced
control that normally does not need to be changed. Setting this to a
value other than the factory default, may cause invalid measurement
results.
OFF - the Data Points is uncoupled from the Integration BW.
ON - couples the Data Points to the Integration BW.
Factory Preset
and *RST: ON
Remarks: You must be in the cdmaOne, cdma2000, W-CDMA
(3GPP), W-CDMA (Trial & Arib), or Basic mode to use
this command. Use INSTrument:SELect to set the
mode.
Channel Power—Sweep Time
[:SENSe]:CHPower:SWEep:TIME <time>
[:SENSe]:CHPower:SWEep:TIME?
Sets the sweep time when using the sweep mode.
Factory Preset
and *RST: 68.27
µs
17.07
µs for W-CDMA (3GPP), W-CDMA (Trial & Arib)