Filter
Top Products
328 Chapter 5
Language Reference
SENSe Subsystem
Range: 1 µs to 50 ms
Default Unit: seconds
Remarks: You must be in Basic, cdmaOne, cdma2000, W-CDMA
(3GPP), or W-CDMA (Trial & Arib) mode to use this
command. Use INSTrument:SELect to set the mode.
History: Version A.03.00 and later
Channel Power—Sweep Time
[:SENSe]:CHPower:SWEep:TIME:AUTO OFF|ON|0|1
[:SENSe]:CHPower:SWEep:TIME:AUTO?
Selects the automatic sweep time, optimizing the measurement.
Factory Preset
and *RST: ON
Remarks: You must be in Basic, cdmaOne, cdma2000, W-CDMA
(3GPP), or W-CDMA (Trial & Arib) mode to use this
command. Use INSTrument:SELect to set the mode.
History: Version A.03.00 and later
Channel Power—Trigger Source
[:SENSe]:CHPower:TRIGger:SOURce
EXTernal[1]|EXTernal2|IMMediate
[:SENSe]:CHPower:TRIGger:SOURce?
Select the trigger source used to control the data acquisitions. This is an
Advanced control that normally does not need to be changed.
EXTernal 1 - front panel external trigger input
EXTernal 2 - rear panel external trigger input
IMMediate - the next data acquisition is immediately taken (also
called Free Run).
Factory Preset
and *RST: IMMediate
Remarks: You must be in the cdmaOne, cdma2000, W-CDMA
(3GPP), W-CDMA (Trial & Arib), or Basic mode to use
this command. Use INSTrument:SELect to set the
mode.