Filter
Top Products
232 Chapter 5
Language Reference
DISPlay Subsystem
Default Unit: dBm, for Spectrum
Remarks: May affect input attenuator setting.
To use this command, the appropriate mode should be
selected with INSTrument:SELect.
Front Panel
Access: When in Spectrum measurement:
Amplitude Y Scale, Ref
Level
Turn a Trace Display On/Off
:DISPlay:TRACe[n][:STATe] OFF|ON|0|1
:DISPlay:TRACe[n][:STATe]?
Controls whether the specified trace is visible or not.
n is a sub-opcode that is valid for the current measurement. See the
“MEASure Group of Commands” on page 255 for more information
about sub-opcodes.
Factory Preset
and *RST: On
Range: The valid traces and their sub-opcodes are dependent
upon the selected measurement. See the following
table.
The trace name assignment is independent of the
window number.
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
Front Panel
Access:
Display, Display Traces
Measurement Available Traces Markers
Available?
ACP - adjacent channel power
(Basic, cdmaOne, cdma2000, W-CDMA
(3GPP), W-CDMA (Trial & Arib),
iDEN, NADC, PDC modes)
no traces no markers
BER - bit error rate
(iDEN mode)
no traces no markers