Filter
Top Products
334 Chapter 5
Language Reference
SENSe Subsystem
Remarks: You must be in the Basic, cdma2000, W-CDMA (3GPP),
or W-CDMA (Trial & Arib) mode to use this command.
Use INSTrument:SELect to set the mode.
Power Statistics CCDF—Sweep Time
[:SENSe]:PSTatistic:SWEep:TIME <time>
[:SENSe]:PSTatistic:SWEep:TIME?
Set the length of measurement interval that will be used.
Factory Preset
and *RST: 1.0 ms
Range: 0.1 ms to 10 ms
Resolution: 0.001 ms
Step: 0.001 ms
Default Unit: seconds
Remarks: You must be in the Basic, cdma2000, W-CDMA (3GPP),
or W-CDMA (Trial & Arib) mode to use this command.
Use INSTrument:SELect to set the mode.
Power Statistics CCDF—Trigger Source
[:SENSe]:PSTatistic:TRIGger:SOURce
EXTernal[1]|EXTernal2|FRAMe|IF|IMMediate|RFBurst
[:SENSe]:PSTatistic:TRIGger:SOURce?
Set the trigger source used to control the data acquisitions.
EXTernal 1 - front panel external trigger input
EXTernal 2 - rear panel external trigger input
FRAMe - uses the internal frame timer, which has been
synchronized to the selected burst sync.
IF - internal IF envelope (video) trigger
IMMediate - the next data acquisition is immediately taken,
capturing the signal asynchronously (also called Free Run).
RFBurst - wideband RF burst envelope trigger that has automatic
level control for periodic burst signals.
Factory Preset
and *RST: IMMediate