Filter
Top Products
Chapter 5 345
Language Reference
SENSe Subsystem
Remarks: You must be in the NADC or PDC mode to use this
command. Use INSTrument:SELect to set the mode.
Reference Oscillator Commands
Reference Oscillator External Frequency
[:SENSe]:ROSCillator:EXTernal:FREQuency <frequency>
[:SENSe]:ROSCillator:EXTernal:FREQuency?
Specify to the frequency of the external reference being supplied to the
instrument. Switch to the external reference with ROSC:SOUR.
Preset
and *RST: Value remains at last user selected value (persistent)
Factory default, 10 MHz
Range: 1 MHz to 30 MHz, with 1 Hz steps
Default Unit: Hz
Remarks: Global to system
Front Panel
Access:
System, Reference, Ref Oscillator
Reference Oscillator Rear Panel Output
[:SENSe]:ROSCillator:OUTPut[:STATe] OFF|ON|0|1
[:SENSe]:ROSCillator:OUTPut?
Turn on and off the 10 MHz frequency reference signal going to the rear
panel.
ESA? - Option oscillator commands, if applicable, are found as
SENSe:OPTion:ROSCillator.
Preset
and *RST: Persistent State with factory default of On
Remarks: Global to system. Was SENS:ROSC:REAR
Front Panel
Access:
System, Reference, 10 MHz Out