Filter
Top Products
332 Chapter 5
Language Reference
SENSe Subsystem
RF Port Power Range Auto
[:SENSe]:POWer[:RF]:RANGe:AUTO OFF|ON|0|1
[:SENSe]:POWer[:RF]:RANGe:AUTO?
Select the RF port power range to be set either automatically or
manually.
ON - power range is automatically set as determined by the actual
measured power level at the start of a measurement.
OFF - power range is manually set
Factory Preset
and *RST: ON
Remarks: You must be in the cdmaOne, EDGE(w/GSM), GSM,
NADC, PDC, cdma2000, W-CDMA (3GPP), or W-CDMA
(Trial & Arib) mode to use this command. Use
INSTrument:SELect to set the mode.
Front Panel
Access:
Input, Max Total Pwr (at UUT)
RF Port Power Range Maximum Total Power
[:SENSe]:POWer[:RF]:RANGe[:UPPer] <power>
[:SENSe]:POWer[:RF]:RANGe[:UPPer]?
Set the maximum expected total power level at the radio unit under
test. This value is ignored if RF port power range is set to auto.
External attenuation required above 30 dBm.
Factory Preset
and *RST:
−15.0 dBm
Range:
−100.0 to 80.0 dBm for EDGE, GSM
−100.0 to 27.7 dBm for cdmaOne, iDEN
−200.0 to 50.0 dBm for NADC, PDC
−200.0 to 100.0 dBm for cdma2000, W-CDMA (3GPP),
W-CDMA (Trial & Arib)
Default Unit: dBm
Remarks: Global to the current mode. This is coupled to the RF
input attenuation
You must be in the Service, cdmaOne, EDGE(w/GSM),
GSM, NADC, PDC, cdma2000, W-CDMA (3GPP), or
W-CDMA (Trial & Arib) mode to use this command.
Use INSTrument:SELect to set the mode.