Filter
Top Products
Chapter 5 357
Language Reference
SENSe Subsystem
Factory Preset
and *RST: AUTO
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
Spectrum—Trigger Source
[:SENSe]:SPECtrum:TRIGger:SOURce
EXTernal[1]|EXTernal2|FRAMe|IF|LINE|IMMediate|RFBurst
[:SENSe]:SPECtrum:TRIGger:SOURce?
Select the trigger source used to control the data acquisitions.
EXTernal1 - front panel external trigger input
EXTernal2 - rear panel external trigger input
FRAMe - internal frame timer from front panel input
IF - internal IF envelope (video) trigger
LINE - internal line trigger
IMMediate - the next data acquisition is immediately taken (also
called free run)
RFBurst - wideband RF burst envelope trigger that has automatic
level control for periodic burst signals
Factory Preset
and *RST: IMMediate (free run)
RFBurst, for GSM, iDEN mode
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
Waveform (Time-Domain) Measurement
Commands for querying the waveform measurement results and for
setting to the default values are found in the “MEASure Group of
Commands” on page 255. The equivalent front panel keys for the
parameters described in the following commands, are found under the
Meas Setup key, after the Waveform (Time Domain) measurement has
been selected from the
MEASURE key menu.
Waveform—Data Acquisition Packing
[:SENSe]:WAVeform:ACQuistion:PACKing AUTO|LONG|MEDium|SHORt
[:SENSe]:WAVeform:ACQuistion:PACKing?