Filter
Top Products
Chapter 5 397
Language Reference
TRIGger Subsystem
Front Panel
Access:
Mode Setup, Trigger, RF Burst, Delay
RF Burst Trigger Level
:TRIGger[:SEQuence]:RFBurst:LEVel <rel_power>
:TRIGger[:SEQuence]:RFBurst:LEVel?
Set the trigger level when using the RF Burst (wideband) Trigger. The
value is relative to the peak of the signal. RF Burst is also known as RF
Envelope.
Factory Preset
and *RST:
−6.0 dB
Range:
−25.0 to 0.0 dB
−200.0 to 0.0 dB for NADC, PDC
Default Unit: dB
Front Panel
Access:
Mode Setup, Trigger, RF Burst, Peak Level
RF Burst Trigger Slope
:TRIGger[:SEQuence]:RFBurst:SLOPe NEGative|POSitive
:TRIGger[:SEQuence]:RFBurst:SLOPe?
Set the trigger slope when using the RF Burst (wideband) Trigger.
Factory Preset
and *RST: Positive
Remarks: You must be in the cdmaOne, cdma2000, W-CDMA
(3GPP), or W-CDMA (Trial & ARIB) mode to use this
command. Use :INSTrument:SELect to set the mode.
Front Panel
Access:
Mode Setup, Trigger, RF Burst, Slope