Filter
Top Products
ST 3000 Release 300 and SFC Model STS103 User’s Manual 6/08
66
6.2 Overview, Continued
Configuration
decision summary
The flowchart in Figure 25 summarizes the typical entries/selections
decisions associated with configuring an ST 3000 pressure transmitter.
Figure 25 Flowchart — ST 3000 Pressure Transmitter Configuration.
Have you
assigned a unique
"tag number" for
the transmitter?
Start
NO
YES
Assign a unique tag number consisting of up to 8
alphanumeric characters to identify this transmitter.
Establish communications and
enter assigned Tag Number at
SFC configuration prompt TAG
NO.
See procedure in Table 21 for entry details.
Press [
ID] key and acknowledge TRIPS SECURED prompt, if
required, to call up SFC prompt TAG NO. Use [
NUM/ALPHA]
key to toggle between Alpha mode and Numeric mode to
enter alphabetic characters and numbers, respectively,
through SFC keys.
Do you know if
output is to represent
linear or square root
calculation?
NO
YES
Determine if transmitter's output is to represent a
straight linear calculation or a square root calculation
for flow measurements.
Select LINEAR or SQUARE ROOT
through SFC configuration
prompt CONFORMITY.
See procedure in Table 22 for selection details.
Call up SFC configuration prompt CONFORMITY and select
menu item LINEAR or SQUARE ROOT.
A
Continued on next page