Filter
Top Products
6/08 ST 3000 Release 300 and SFC Model STS103 User’s Manual 59
Section 6 —Configuration
6.1 Introduction
Section Contents
This section includes these topics:
Section Topic See Page
6.1 Introduction ..................................................................................59
6.2 Overview ......................................................................................60
6.3 Entering a Tag Number................................................................71
6.4 Selecting Output Form .................................................................73
6.5 Adjusting Damping Time ..............................................................76
6.6 Selecting Unit of Measurement ....................................................78
6.7 Setting Range Values Using SFC ................................................80
6.8 Setting Range Values Using Local Adjustments..........................84
6.9 Selecting Output Signal Mode (DE Mode Only)...........................91
6.10 Selecting Message Format (DE Mode Only).................................94
6.11 Configuring Smart Meter Using SFC............................................96
6.12 Configuring Smart Meter Using Pushbuttons.............................103
6.13 Disconnecting SFC ....................................................................122
About this section
This section introduces you to ST 3000 transmitter configuration. It
identifies the parameters that make up the transmitter’s configuration
database and provides procedures for entering values/selections for the
given configuration parameters.
ATTENTION
If you will be using the SCT 3000 software Release 3.12.2 or greater
instead of an SFC to configure the transmitter, follow the SCT 3000 on-
line help and on-line documentation to configure the transmitter’s
database.