Filter
Top Products
ST 3000 Release 300 and SFC Model STS103 User’s Manual 6/08
164
8.6 Monitoring Local Smart Meter Display, Continued
Display description,
continued
Table 50 Description of Display Indicators Shown in Figure 51, continued
Display Indicator What It Means When Lit
KNOWN VALUE The Upper Value or Lower Value being displayed has previously
been configured to the value shown.
ANALOG Transmitter is in its Analog mode. (When indicator is OFF,
transmitter is in its DE mode)
inH2O Inches of Water is selected engineering units for digital readout
K Multiplies digital reading by 1,000. Turns on automatically when
reading exceeds 1999.
GPH Gallons per hour is selected engineering units for digital readout.
(Note that the FLOW indicator must also be lit to allow this
selection.)
GPM Gallons per minute is selected engineering units for digital
readout. (Note that the FLOW indicator must also be lit to allow
this selection.)
mmHg Millimeters of Mercury is selected engineering units for digital
readout.
PSI Pounds per Square Inch is selected engineering units for digital
readout.
A Transmitter is absolute pressure type. Digital readout represents
absolute values.
Stick-On Label (not shown) Selected engineering unit equals one of these units which is
available as a stick-on label from Honeywell drawing number
30756918-001.
Kpa = Kilopascals
Mpa = Megapascals
mbar = Millibar
bar = Bar
g/cm2 = Grams per Square Centimeter
Kg/cm2 = Kilograms per Square Centimeter
mmH2O = Millimeters of Water
inHg = Inches of Mercury
mH2O = Meters of Water
Typical operation
indications
Table 51 summarizes typical Local Smart Meter indications. Note that
other combinations of status messages are possible.
Continued on next page