Filter
Top Products
ST 3000 Release 300 and SFC Model STS103 User’s Manual 6/08
98
6.11 Configuring Smart Meter Using SFC, Continued
Procedure, continued
Table 30 Setting Up Local Smart Meter Configuration Using an SFC, continued
Step Press Key Read Display or Action Description
3
ENTER
(YES)
NON-VOL
SCFO
W
RK NI.G..
CMe ntr oef
ig
Perts
en
Met re
CMe ntr oef
ig
Bd
Enters meter configuration function
and confirms that Local Smart Meter
is present. Timed prompt - Proceed
to Step 4.
ATTENTION
If prompt “No Meter
Present” appears, prompt times out
in a few seconds, as described
above, and calls up the Configure
Meter? prompt. This means that
you can access the meter
configuration function without the
Local Smart Meter installed.
Proceed to Step 4. If prompt “Mtr
not Supportd” appears, prompt
times out and returns to previous ST
CONFIG prompt (See Step 2.). This
means that you are working with a
pre-release 300 transmitter that
does not support the Local Smart
Meter option and, therefore, can not
access the meter configuration
function.
4
Cnouf
ig
Met re
CMe ntr oef
ig
re ?
Prompt asks if you want to configure
Local Smart Meter. If you want to
configure it, go to Step 5. If you do
not want to configure it, press [
CLR]
key to exit function.
Continued on next page