Filter
Top Products
6/08 ST 3000 Release 300 and SFC Model STS103 User’s Manual 113
6.12 Configuring Smart Meter Using Pushbuttons, Continued
Setting Lower Display
Values,
continued
Table 35 Setting Lower Display Values for Smart Meter Display, continued
Step Action Meter Display
10 Press LOWER VALUE button to lock-in third
digit and activate next active digit.
Readout now displays next active digit which
will be BLANK unless lower value was set to 1
before.
%
1000
ANALOG
UPPER
VALUE
UNITS
LOWER
VALUE
SET
VAR
SEL.
000.
"1" digit is
BLANK or 1
11
Press Increase σ button to set digit to 1 or
Decrease τ button to set it to BLANK.
12 Press LOWER VALUE button to lock-in “1”
digit and activate sign segment.
Readout now displays sign segment which
will be BLANK for positive values unless lower
value was set for negative (–) values before.
“1” digit value setting.
%
1000
ANALOG
UPPER
VALUE
UNITS
LOWER
VALUE
SET
VAR
SEL.
000.
Press to set "1"
digit as 1
Press to set "1"
digit as BLANK
13
Press Increase σ button to set sign segment
to minus sign for negative values or Decrease
τ button to set it to BLANK for positive values.
14 Press LOWER VALUE button to lock in
current settings as lower display value limit.
ATTENTION
For CUSTOM unit in
transmitter with LINEAR output, you must set
both lower and upper display limits for values
to take effect. If you let either the lower or
upper display limit time out (after 30 seconds),
the meter discards both newly set values and
reverts back to the previously set values.
Sign segment setting.
%
1000
ANALOG
UPPER
VALUE
UNITS
LOWER
VALUE
SET
VAR
SEL.
000.
Press to set sign
segment as minus
sign (-) for negative
values
Press to set sign
segment as
BLANK for
positive values
• If you have not yet set the upper display limit value, the meter automatically enters the upper display
setting function after it displays previously set value, if applicable. Go to Table 36.
• If you have already set the upper display limit value, this completes the lower and upper display
limits setting function for Custom engineering units in the transmitter. Meter returns to normal
operation.
Continued on next page