Filter
Top Products
ST 3000 Release 300 and SFC Model STS103 User’s Manual 6/08
204
11.6 Interpreting Messages, Continued
Interpretation table,
continued
Table 67 Diagnostic Message Interpretation Table, continued
Message Possible Cause What to Do
OTE
.H
SAVE/R
W.M
ES R
ISMATCH
Hardware mismatch. Part of
Save/Restore function.
Nothing – SFC tried to restore as
much of database as possible.
#T 011P3
MODEOUTIN U
STATUS
TP
Transmitter is operating as a
current source.
Press [
OUTPUT] and [CLR] keys to tell
transmitter to exit output mode.
TAG O
LL RAOGE
N.
NSLPIE S E
Transmitter sent illegal response
to SFC
Try communicating again.
TAG O
NV DIBLA
N.
ASDAIA T E
Transmitter database was
incorrect at powerup.
• Try communicating again.
• Verify database configuration.
Manually update non-volatile
memory with each parameter.
URV
ILA
1.
IN
PT 3011
VREQUDEST
• Requesting transmitter to
correct or set its URV to a
value which results in too
small a span, or correct its
LRV or URV while in output
mode.
• Keystroke is not valid for given
transmitter.
• Check that correct URV
calibration pressure is being
applied to transmitter, or that
transmitter is not in output mode.
• Check that keystroke is
applicable for given transmitter.
TAG O
LO PLS
N.
OEWRO
Not enough resistance in series
with communication loop.
Check sensing resistor and increase
resistance to at least 250
Ω.
#T 011P3
OAD.OM. E
STATUS
RVBL
OR
#T 011P3
AULROET Y
STATUS
DEFMB T
Pressure input is two times
greater than URL of transmitter.
• Check range and, if required,
replace transmitter with one that
has a wider range.
• Meter body may have been
damaged. Check the transmitter
for accuracy and linearity
Replace meter body and
recalibrate, if needed.
T 0 1 1 P 3
FAULTE R BMET O
S T A T U S
DY
Electronics (PWA) and meter
body are incompatible.
Obtain matching meter body for
given transmitter model and series.
Check transmitter nameplate for
model number data.
T 011P3
ONSAE
STATUS
RKPNESC
Transmitter sent a negative
response because it could not
process one or more commands.
Check configuration and try again.
Continued on next page