Filter
Top Products
ST 3000 Release 300 and SFC Model STS103 User’s Manual 6/08
92
6.9 Selecting Output Signal Mode (DE Mode Only), Continued
Procedure , continued
Table 28 Selecting Mode of Output Signal Indication, continued
Step Press Key Read Display or Action Description
3
NON-VOL
ENTER
(Yes)
RD INEE
PTDE 3011OCNF
TSFCEN
4BoB/
PTDE 3011OCNF
De
)(
ywt
Enters change in SFC and calls up
next DE configuration parameter.
This action only applies if selection
is changed. Otherwise, must press
[
CLR] key to exit function or [s NEXT]
key to call up next parameter.
4
CLR
(NO)
DCWLO
PTDE 3011OCNF
NNGAHDAOE?
Prompt asks if change entered in
SFC is to be downloaded to
transmitter. If you want to download
change, go to Step 5. If you do not
want to download change, press
[
CLR] key to exit function. This action
only applies when Step 3 is valid.
Otherwise, this keystroke exits DE
CONF function.
5
NON-VOL
ENTER
(Yes)
PTDE 3011OCNF
ORK NGCW .F.S.I
LIN DP
.Y. .READ
TØ11P3
Message exchange is working.
Parameter change is loaded in
transmitter. SFC is ready for next
function.
Continued on next page