Filter
Top Products
ST 3000 Release 300 and SFC Model STS103 User’s Manual 6/08
94
6.10 Selecting Message Format (DE Mode Only)
Background
You can select one of these broadcast formats for the digital signal
transmission as described in Table 20.
•
4-Byte type
•
6-Byte type
Procedure
The procedure in Table 29 outlines the steps for selecting a 6-Byte type
format for example purposes only.
Table 29 Selecting Message Format
Step Press Key Read Display or Action Description
1
^
SHIFT
DE CONF
MENU
ITEM
I
LIN DP
FT–SHI
TØ11P3
ORK NGCW .F.S.I
PTDE 3011OCNF
eRgnliSn
PTDE 3011OCNF
g
w/SV
Initiate shift key selection.
Calls up DE CONFIG menu. Output
signal mode selection appears.
2
NEXT
H
4BoB/
PTDE 3011OCNF
De
)(
ywt
Calls up next DE CONFIG menu
item - Message format selection
appears.
3
DE CONF
MENU
ITEM
I
6B/Bw
PTDE 3011OCNF
De
)(
yt
Calls up next message format
selection. Repeatedly press [
MENU
ITEM
] key to cycle between two
format selections. See Table 19 for
details. Stop when “w/DB (6 Byte)”
selection is on display.
4
NON-VOL
ENTER
(Yes)
RD INEE
PTDE 3011OCNF
TSFCEN
/S=/
PTDE 3011OCNF
BLoFO
Enters change in SFC and calls up
next DE configuration parameter.
This action only applies if selection
is changed. Otherwise, must press
[
CLR] key to exit function, [s NEXT]
key to call up next parameter, or
[t
PREV] key to call up previous
parameter.
5
CLR
(NO)
DCWLO
PTDE 3011OCNF
NNGAHDAOE?
Prompt asks if change entered in
SFC is to be downloaded to
transmitter. If you want to download
change, go to Step 6. If you do not
want to download change, press
[
CLR] key to exit function. This action
only applies when Step 4 is valid.
Otherwise, this keystroke exits DE
CONF function.
Continued on next page