DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-118ANN-PT (Announcement Port)
9
140AY Channel Sanity Inquiry Test (#222)
The Angel keeps a sanity status bit for each of the 16 channels on the 140AY
device. This test queries the Angel to determine the status for a particular
channel. If a channel is insane, that implies that announcements cannot be
played back on that channel.
1 to 254 FAIL Test failed. The error code indicates the number of byte count errors found
by the Tone Detector.
1. Reset the circuit pack via the reset board UUCSS command and then
run this test again. If the test continues to fail, replace the circuit pack.
2. If there are recurring alarms on this port caused by this test failing,
replace the circuit pack even if Step 1 works.
!
CAUTION:
Replacing the circuit pack results in loss of integrated
announcements. Refer to Essential Service Information at the
beginning of ‘‘ANN-BD (Announcement Circuit Pack)’’
in this
chapter.
255 FAIL Test failed. The announcement port and the tone detector never
synchronized. Check for active GPTD-PT errors, and refer to “GPTD-PT
(General Purpose Tone Detector Port)” to diagnose them first.
1. If there are no active GPTD-PT errors, reset the circuit pack using the
reset board UUCSS command and then run this test again. If the test
continues to fail, replace the circuit pack.
2. If there are recurring alarms on this port caused by this test failing,
replace the circuit pack even if Step 1 works. See Caution, above.
PASS This port can cleanly play announcements. User-reported troubles on this
pack should be investigated using other port and circuit pack tests. Refer
to ‘‘ANN-BD (Announcement Circuit Pack)’’
for a description of the circuit
pack tests.
Table 9-46. TEST #206 Playback Speech Memory Array (PSMA) Test — Continued
Error
Code
Te st
Result Description/Recommendation
Continued on next page
