DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-11Common Abort and Fail Codes
8
1338 ABORT The system could not execute the command on a component on
the Standby SPE because an interchange was pending.
1. Refer to ‘‘STBY-SPE (Standby SPE Maintenance)’’
in Chapter
9.
2. Try the command again after the SPE interchange occurs.
1339 ABORT The system could not execute the command on a component on
the Standby SPE because an handshake communication was
down.
1. Refer to ‘‘STBY-SPE (Standby SPE Maintenance)’’
in Chapter
9.
2. Try the command again after the standby SPE is restored to
service. Use
status spe
to determine state of standby SPE.
1347 ABORT The system could not execute the command on a component on
the Standby SPE because memory refresh was not complete.
1. Refer to ‘‘STBY-SPE (Standby SPE Maintenance)’’
in Chapter
9.
2. Try the command again after the standby SPE is restored to
service. Use
status spe
to determine state of standby SPE.
1350 ABORT The system could not execute the command on a component on
the Standby SPE because memory shadowing was not enabled.
1. Refer to ‘‘STBY-SPE (Standby SPE Maintenance)’’
in Chapter
9.
2. Try the command again after the standby SPE is restored to
service. Use
status spe
to determine state of standby SPE.
2012
2500
ABORT Internal system error.
2100 ABORT System resources to run this command were unavailable.
1. Try the command again at 1-minute intervals up to 5 times.
Table 8-3. Common Error Codes for Busyout, Release, Test,
and Reset Commands — Continued
Error
Code
Command
Result Description/Recommendation
Continued on next page
