DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Additional Maintenance Procedures
6-47Automatic Transmission Measurement System (ATMS)
6
Input Parameters - List Testcall Command
ATMS Summary Reports
The ATMS Summary Report summarizes, on a trunk group basis, the collective
results of the latest ATMS tests performed on each trunk group. By interacting
with the trunk group form, it highlights out-of-tolerance measurements. Marginal
trunks are highlighted, and unusable trunks blink, allowing you to quickly identify
out-of-tolerance or unusable trunks. Screen 6-2
shows a typical summary report.
detail This qualifier specifies a detailed report that shows each measurement
made for each trunk.
summary This qualifier specifies a report that shows totaled results of ATMS tests
for trunk groups as a whole.
grp # This qualifier specifies a report showing measurements for a specific
trunk group. When used with
to-grp
, this option specifies the starting
trunk group in a range.
to-grp This qualifier specifies a report showing measurements for all trunk
groups from 1 up to the trunk group number entered. When used with
grp
, this is the ending trunk group in a range.
mem Used with
grp
, this qualifier specifies a report showing measurements for
a specific trunk group member. When used with
to-mem
, this is starting
trunk group member in a range.
to-mem Used with
grp
, this qualifier specifies display of measurements for all
trunk group members from 1 up to the specified trunk group member
entered. When used with
mem
, this is the ending trunk group member in
a range.
port This qualifier specifies display of measurements for the trunk assigned to
a specific port circuit.
result Only measurements that match the specified result are displayed. Result
IDs include
pass
,
marg
,
fail
, and numerical abort codes.
not-result Only measurement results that do not match the specified result are
displayed.
count number This qualifier limits the total number of records displayed.
print With this qualifier, the command executes immediately (if resources are
available) and sends output both to the screen and to a printer
connected to the terminal where the command was entered.
schedule With this qualifier, a scheduling form is displayed which allows you to
specify a start time for the command. The command is placed in the
queue and, when executed, sends the output to the system printer.
