DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1714TDM-BUS (TDM Bus)
9
Procedure 2 (Non-Destructive)
If you are at the site
, reseat the circuit pack. This action will cause the circuit pack
that was in the reset state to begin functioning on the
current
Control Channel
bus.
Procedure 3 (Destructive)
Reset the port network that contains the circuit pack that is in the reset state.
When a network is reset, two restart messages, one on the control channel of
each TDM Bus, are sent to each circuit pack on the network.
To reset an EPN
only
, execute the
reset port-network
P
level 2
command.
Resetting the EPN will
disrupt all calls going to and originating from the EPN.
Procedure 4 (Destructive)
Execute the
recycle carrier
PC
command.
This command will remove and return
power to the designated port carrier. Thus, any other circuit packs on this carrier
will also be temporarily taken out-of-service.
Error Log Entries and Test to Clear Values
Table 9-640. TDM Bus Error Log Entries
Error
Type
Aux
Data Associated Test Alarm Level
On/Off
Board
Test to Clear
Value
0 0 Any Any Any test tdm P
1 0 Control Channel Test (#296) MINOR ON test tdm P r 3
18(a) 0 busyout tdm PC WARNING ON release tdm PC
35(b) 0-1 TDM Bus Corruption MINOR ON set tdm PC
257(c) 0 None MAJOR ON
513(d) Any Idle Time Slot Test (#294) MINOR ON test tdm P r 3
769(e) Any Idle Time Slot Test (#294) WARNING ON test tdm P r 3
769(f) Any Idle Time Slot Test (#294) (see Notes)
1025(g) Any None
3872(h) Any None
3873(h) Any None
3874(h) Any None
3877(h) Any None
