DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-85ANL-LINE, ANL-NE-L (8-Port Analog Line)
9
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port’s message lamp state (if it has one) and
translations (such as station type, dial type, network connection) with information
kept in the software. The software is updated with the switchhook state reported
by the port processor. When the ringer is in the off state, this test also turns off
the station’s ringer to prevent constant ringing caused by defective hardware.
PASS The port’s battery feed chip is able to provide power to the station
equipment to detect on-/off-hook. However, the battery feed chip may still
be unable to provide power for touch-tones. If tones are heard when
buttons are pressed, then the battery feed chip is functioning correctly;
otherwise, replace the circuit pack because this port is defective.
User-reported troubles on this port should be investigated by using other
port tests, by examining station wiring, by examining the station, and by
ensuring that the terminal is correctly translated as off-premises or
on-premises.
NOTE:
This test always passes for circuit packs TN712 prior to Vintage 14
and TN742 prior to Vintage 6.
0NO
BOARD
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use the list
config command, and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, issue the
busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should re-establish the
linkage between the internal ID and the port. If this is not the case,
dispatch to check to ensure that there is a valid board inserted.
Table 9-34. TEST #35 Battery Feed Test Results — Continued
Error
Code
Te s t
Result Description/ Recommendation
Continued on next page
