DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-547DISK (MSS Disk Circuit Pack)
9
A SCSI READ DEFECT DATA command is sent to the Disk Drive. This
returns the addresses of bad blocks on the disk that must be mapped
around.
■ Device Diagnostic Tests: A SCSI SEND DIAGNOSTICS command is sent
to the Disk Drive to initiate a set of device-dependent self-tests that run as
a unit. Failures can be for multiple reasons and the return code that
indicates the cause of failure is vendor unique. A failure condition reports
as single failure type since the only repair action is to replace the Disk
Drive circuit pack
Table 9-224. TEST #809 Disk Reset Test
Error
Code
Te st
Result Description/ Recommendation
526 ABORT The Host Adapter has been busied out.
1. Issue the release host-adapter command.
1316 ABORT Could not get access to the MSS. Other application software may be using it or
background maintenance tests may be running.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, verify that the daily translation-save operation
is not in progress (use display system-parameters maintenance to
display the time for scheduled maintenance and the "y/n" option for saving
translation daily).
1335 ABORT Could not run the test on the Standby SPE—Duplication not administered.
1. Refer to “STBY-SPE”.
2. Administer standby present.
1338 ABORT Could not run the test on the Standby SPE—Interchange pending.
1. Refer to “STBY-SPE”.
2. After interchange occurs, run test on new active SPE.
1339 ABORT Could not run the test on the Standby SPE—Handshake down.
1. Refer to “STBY-SPE”.
2. When the standby is restored to service (use status spe to determine
state of standby) retry the command.
1347 ABORT Could not run the test on the Standby SPE—Refresh not complete.
1. When the standby is restored to service (use status spe to determine
state of standby) retry the command.
1350 ABORT Could not run the test on the Standby SPE—Shadowing not enabled.
1. When the standby is restored to service (use status spe to determine
state of standby) retry the command.
Continued on next page
