DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
About this Book
xxiiConventions Used in This Document
— All occurrences of G3siV4, G3siV4+m, G3siV5, and G3siV5+m are
called G3si unless a specific configuration is required to
differentiate among product offerings
— All occurrences of G3 with out a suffix following the “3” refer to
G3vs, G3si, and G3r
■ A component of a DEFINITY System, such as a circuit pack, occurring
without a reference to any specific system, is part of G3
■ DEFINITY Communications Sever is abbreviated DEFINITY ECS
■ All physical dimensions in this book are in English (Foot Pound Second)
(FPS) followed by metric Centimeter Grams Second) (CGS) in parenthesis.
Wire gauge measurements are in AWG followed by the diameter in
millimeters in parenthesis.
■ Information you type at the management terminal is shown in the following
typeface:
list system-parameters maintenance
■ Information displayed on the management terminal screen is shown in the
following typeface:
login
■ Keyboard keys are shown in the following typeface: Enter.
■ Circuit pack codes (such as TN790 or TN2182B) are shown with the
minimum acceptable alphabetic suffix (like the ‘‘B” in the code TN2182B).
Generally, an alphabetic suffix higher than that shown is also acceptable.
However, not every
vintage
of either the minimum suffix or a higher suffix
code is necessarily acceptable.
NOTE:
Refer to
Technical Monthly: Reference Guide for Circuit Pack
Vintages and Change Notices
, for current information about the
usable vintages of specific circuit pack codes (including the suffix)
in a Release 7 system.
■ Admonishments used in this book are as follows:
!
CAUTION:
This sign is used to indicate possible harm to software, possible loss
of data, or possible service interruptions.
!
WARNING:
This sign is used where there is possible harm to hardware or
equipment.
!
DANGER:
This sign is used to indicate possible harm or injury to people.
