DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-68disable suspend-alm-orig
8
Description
This command disables one or more active Suspend Alarm Origination entries
from the Suspend Alarm Origination table. This command disables all entries
(boards and ports) matching the specified physical board location.
NOTE:
A port entry cannot be disabled with this command. Allowing for different
ways to disable one or more entries greatly increases the complexity of
updating and displaying the Suspend Alarm Origination table.
Defaults
None.
Parameter
Help Messages
N is the maximum number of cabinets in the switch:
Enter board location:[cabinet(1-N)];
carrier(A-E);slot(0-20)
Output
The command returns one of the following messages:
1. If the board specifier is not valid:
Board invalid
2. If no entries can be disabled in the Suspend Alarm Origination table:
Entry not found; no entries disabled
Feature Interactions
None.
board
location
This parameter specifies the physical board location of the hardware
component that has been replaced or corrected. A port location is not
supported because of it complexities.
