DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Management Terminal
3-11Switch-Based Bulletin Board Message Notification
3
4. Enter super-user or non-super-user in the Service Level field. Default is
non-super-user.
■ “super-user” gives access to the
add, change, display, list,
and
remove
commands for all customer logins and passwords. The
super-user can administer any mix of super-user/non-super-user
logins up to a total of ten additional system logins.
■ “non-super-user” permissions are limited by restrictions specified
by the super-user when administering the non-super-user login. A
non-super-user can change his/her password with permission set
by the super-user, however once a password has been changed
the non-super-user must wait 24 hours before changing the
password again. A non-super-user cannot change other user
passwords, login characteristics, or permissions.
5. Enter
y
in the
Disable Following a Security Violation
field to
disable a login following a login security threshold violation. This field is a
dynamic field and only appears on the Login Administration form when the
SVN Login Violation Notification feature is enabled. The system default for
the
Disable Following a Security Violation
field is
y
.
6. Enter
y
in the
Access to INADS Port?
field to allow access to the
remote administration port. This field only displays if Acct. has first
enabled customer super-user access to the INADS Remote Administration
Port. Default is
n
. This step is valid for V4 and higher systems only.
7. Enter a password for the new login in the Login’s Password field. A
password must be from 4 to 11 characters in length and contain at least 1
alphabetic and 1 numeric symbol. Valid characters include numbers,
and!&*?;’^ (),.:- (the system will not echo the password to the screen as
you type).
8. Re-enter the password in the Login’s Password field. The system will not
echo the password to the screen as you type.
9. Enter the number of days (1 to 99) from the current day, that you want the
password to expire, in the Password Aging Cycle Length field. If a you
enter a blank in this field, password aging does not apply to the login.
10. Decide whether or not to leave the default of yes (“y”) in the
Facility
Test Call Notification?
field. If you retain the default, the user
receives notification at logoff that the facility test call feature access code
is administered. If you do not want the notification to appear, set the field
to n.
!
CAUTION:
Leaving The facility Test Call administered after logging off poses a
significant security risk.
11. Decide whether or not to leave the default of yes (“y”) in the Facility Test
Call Notification Acknowledgment Required field. If you retain the default,
the user is required to acknowledge that they wish to logoff while Facility
