DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1505STBY-SPE (Standby SPE Maintenance)
9
that problem, (usually by replacing the circuit pack). Then the SOH problem
should eventually clear. If you lock-and-power-down the standby SPE to replace
the given pack, you’ll need to test it while in locked mode until all tests pass and
then unlock and wait for system software to re-initialize the standby SPE. Only
then should you expect standby SOH to be improved to level
functional.
If neither the recent interchange mode nor a standby component alarm exist, but
standby SOH persists at level
partially functional
, escalate the problem.
Error Log Entries and Test to Clear Values
Notes:
a. Indicates that a single handshake attempt has failed. Use "status spe" to
see if handshake is down. If "status spe" indicates that handshake is up,
ignore this error. If handshake is down, see
Resolving Handshake Failure
.
Table 9-569. STBY-SPE Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Of
f
Board Test to Clear Value
0
1
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0 Any Any Any test spe-standby l
1(a) Standby SPE Handshake Test
(#919)
MAJOR OFF
18(b) busyout spe-standby WARNING OFF rel spe-standby
103(c) None MINOR OFF test spe-standby l
257(d) standby SPE status query
(#855)
MAJOR OFF
260(e) standby SPE status query
(#855)
MAJOR OFF
514(f) None MAJOR OFF
770(g) standby SPE TOD Comparison
Test (#858)
MINOR OFF test spe-standby l
1025(h) standby SPE status query
(#855)
MAJOR OFF test spe-standby l
1281(i) any standby SPE status query
(#855)
MAJOR OFF
1537(j) any standby SPE configuration
Matchup test (#920)
MAJOR OFF test spe-standby l
