DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-3Common Input Parameters
8
port circuit 6 on the circuit pack in cabinet 5, carrier C, slot 6. The
list
and
display
commands are useful in relating MO locations to information such as PN
number, extension, link numbers, and so forth. Table 8-2
contains information
about the less-common command parameters.
Table 8-2. Less-Common Test Command Parameters
Parameter Range Default Meaning
PN#
One or two-digit port network number. EPN cabinets
may contain one or two port networks. Use
list
cabinet
to find which port networks are in each
cabinet.
print
This command executes immediately (if resources
are available) and sends output both to the screen
and to a printer connected to the terminal where the
command was entered. This option is available for
display
,
list
and
status
commands.
schedule
A scheduling form is displayed which allows you to
specify a start time for the command. The command
is placed in the queue and, when executed, sends
the output to the system printer. The
schedule
option is available for
display
,
list
and
test
commands. When used with
display alarms
or
errors
, a full report is generated. The usual selection
form for error and alarm reports is suppressed so
that it will not interfere with the command’s execution
when it is issued from the queue.
You can see what commands are currently queued
with the
list command-queue
command. A queued
command can be canceled with
remove
command-queue
job#. This option requires that the
system printer be administered on page 4 of the
Feature-Related System Parameters form.
group#
1-666 One to three-digit trunk group number; used to
address trunk maintenance objects.
group#/
member#
1-255 Group number followed by a slash and the one to
three-digit member number of an individual trunk;
used to address trunk maintenance objects.
Continued on next page
