DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Additional Maintenance Procedures
6-42Automatic Transmission Measurement System (ATMS)
6
Running ATMS Tests
(Test Analog-Testcall Command)
ATMS test calls can be originated either on demand or according to the ATMS
Test Schedule. Test schedules are set up with test-schedule commands which
are described in
DEFINITY Enterprise Communications Server Release 5.4
Administration and Feature Description
.
Demand test calls are originated by the test analog-testcall command. You can
specify testing of an entire trunk group, an individual trunk, or all trunks on a
single circuit pack. Trunks can be addressed by either group/member numbers
or circuit pack/port locations. The type of test call, the number of the testing line
on the far-end switch and various other parameters must be administered on the
trunk group form before the command can execute.
Table 6-7. ATMS Administration
Form Field Entry/Remarks
System-parameters
customer options
ATMS?
y
(You must logoff/login in order for
changes on this form to take effect.)
Station Extension At least one TN711 analog port must
be assigned.
Port Number
UUCSS01
where UUCSS is the
location of any TN771
Port Type COR
105TL
The number of a COR that has
testing enabled (see next form)
Class of Restriction Facility Access Trunk Test
y
Trunk Group Maintenance Tests?
ATMS Thresholds (page 4
of form)
y
This page is used to specify
performance thresholds, the type
and access number of the far-end
TTL, and system response to test
failures.
Hunt Group (Optional, for incoming test calls) If
the system has several TN771s, you
can use this form to make up a hunt
group of TTLs so that one extension
can be used for the whole pool.
ATMS Trunk Test
Schedule
(Optional) To set up a test schedule,
see Chapter 4 of
Generic 3 V2
Implementation,
555-230-653
.
