Filter
Top Products
Instructions for Operation
Operating Information
2Ć16
Figure 2Ć6:ăMODE Menu
H Triggered Mode Ċ In triggered mode, the AWG2005 outputs the
specified waveform or sequence waveform once, when a trigger
occurs.
H Gated Mode Ċ In gated mode, the gate signal controls the waveĆ
form or sequence output.
As long as the front panel MANUAL button is pushed, (or the gating
signal is high) the AWG2005 outputs the specified waveform or
sequence. When the MANUAL button is released (or the gating
signal goes low), the waveform output stops. When the MANUAL
button is pushed again, the output resumes from the level at which
the waveform or sequence output stopped.
H Waveform Advance Mode Ċ When a sequence file has been
designated in the SETUP menu, Waveform Advance mode is used
to advance a waveform in sequence each time a trigger is received.
The waveform output conditions in waveform advance mode can be
set to either Continuous or Step depending on the selection for the
Run side menu item.