Filter
Top Products
Removal and Installation Procedures
AWG2005 Service Manual
6Ć37
Rear BNC Connectors
1. Assemble equipment and locate modules to be removed:
a. You will need a
1
@
2
Ćinch openĆend wrench to do this procedure.
b. Locate the modules to be removed in the locator diagram, Internal
Modules, in Figure 6Ć4. (An instrument with Option 05 has an addiĆ
tional BNC connector.)
2. Orient instrument: Set the AWG2005 with the top down on the work
surface and the left side facing you (see Figure 6Ć16).
3. Remove rear BNC connectors:
a. Disconnect the interconnect cables at the CH1 AM IN and CH1 ADD
IN connectors.
b. Using the openĆend wrench, remove the nut securing the BNC
connectors to the chassis. Then, lift the BNC connectors out of the
chassis to complete the removal.
c. For and instrument with Option 05, remove the SWEEP OUT conĆ
nector using the same procedure.
4. Reinstallation: Install the rear BNC connectors by doing substeps 3a and
3b in reverse order.
ADD IN
Connector
AM IN
Connector
Disconnect
SWEEP OUT
Connector
(Option 05)
Figure 6Ć16:ăRear BNC Connectors Removal