Filter
Top Products
Removal and Installation Procedures
Maintenance
6Ć24
FrontĆpanel Module
NOTE
This procedure includes removal and reinstallation instructions for
the frontĆpanel module and frontĆpanel buttons. Unless either of
those modules are being serviced, do not do step 6, Further
disassembly of FrontĆpanel Module."
1. Assemble equipment and locate modules to be removed:
a. You will need a flatĆbladed screwdriver and a 0.05Ćinch and
1
@
16
Ćinch
hex wrench to do this procedure.
b. Locate the modules to be removed in the locator diagram, External
Modules, in Figure 6Ć3.
c. Do the procedure, Front Cover, Trim Ring, and Menu Buttons,
stepsĂ1-6 (immediately preceding this procedure).
2. Remove frontĆpanel knob: Do the FrontĆpanel Knob procedure, on
pageĂ6Ć17.
3. Remove front cover, trim ring, and menu buttons: Do the Front Cover,
Trim Ring, and Menu Buttons procedure on page 6Ć22 removing only the
module(s) you want to service.
4. Orient instrument: Set the AWG2005 with the bottom down on the work
surface and the front facing you.
5. Remove frontĆpanel module:
a. As shown in Figure 6Ć9, release the snap at the right of the frontĆ
panel module using a flatĆbladed screwdriver. Lift the frontĆpanel
module out of the chassis until you can reach the interconnect
cable.
b. Disconnect the ribbon interconnect cable at J101 and flexible board
connector at JP301 on the A12 Keyboard assembly. Disconnect the
interconnect cable at the TRIGGER INPUT connector.
c. Finally, lift the frontĆpanel module out of the chassis to complete the
removal.