Removal and Installation Procedures
AWG2005 Service Manual
6Ć23
Trim Ring : when removing the
trim ring, grasp its back edge and
vigorously flex it upward before
pulling it forward.
Menu Buttons
Trim Ring
Figure 6Ć8:ăFront Cover, Trim Ring, and Menu Button Removal
(Front Cover not Shown)
CAUTION
To prevent contaminating AWG2005 parts, do not touch the carbon
contact points on the menu buttons installed in the trim ring. Also,
do not touch the contacts on the flex circuit exposed when you
remove the trim ring.
5. Remove trim ring: Grasp the trim ring by the top edge and pry it up and
lift it forward to snap it off of the trim ring. If servicing the menu buttons,
lift them out of the trim ring. (When reinstalling, reinsert the menu butĆ
tons, align the trim ring to the chassis and press it back on.)
6. Reinstallation: Do steps 3-5 in reverse order to reinstall the menu
buttons, trim ring and the front cover, following the reinstallation instrucĆ
tions found in each step.