Filter
Top Products
AWG2005 Service Manual
6Ć1
Before Maintenance
This section contains the information needed to do periodic and corrective
maintenance on the AWG2005 Arbitrary Waveform Generator. Specifically,
the following subsections are included:
H Before Maintenance Ċ This subsecton includes general information on
preventing damage to internal modules when doing maintenance.
H Inspection and Cleaning Ċ Information and procedures for inspecting
the AWG2005 and cleaning its external and internal modules.
H Removal and Installation Procedures Ċ How to remove defective modĆ
ules and replace new or repaired modules.
H Repackaging Ċ Information on packaging the AWG2005 properly for
shipment.
H Troubleshooting Ċ Information on isolating failed modules. Included are
instructions on operating the AWG2005 internal diagnostic routines and
troubleshooting flowcharts for fault isolation. Most of the flowcharts use
the internal diagnostic routines to speed fault isolation to a specific
module.
Before performing any of the procedures in the Maintenance section, note
the following:
H Only trained service technicians should perform these procedures.
H Read the Safety Summary located near the beginning of this manual.
H Read the Strategy for Servicing in the frontmatter introduction.
H Read section 2, Operating Information.
Prerequisites