Tektronix AWG2005 Stereo System User Manual


 
Removal and Installation Procedures
Maintenance
6Ć42
Monitor Module and CRT Frame
1. Assemble equipment and locate modules to be removed:
a. You will need a screwdriver with a size TĆ15 Torx tip to do this proceĆ
dure.
b. Locate the modules to be removed in the locator diagram, Internal
Modules, in Figure 6Ć4.
2. Remove front cover, trim ring, and menu buttons: Do the Front Cover,
Trim Ring, and Menu Buttons procedure on page 6Ć22.
3. Orient instrument: Set the AWG2005 with the bottom down on the work
surface and the left side facing you.
4. Remove monitor module:
NOTE
Take care not to damage the CRT surface when installing or removĆ
ing the monitor module.
a. Disconnect the ribbon interconnect cable at J901 on the monitor
module. See Figure 6Ć19.
b. Remove the five screws securing the monitor module top and botĆ
tom to the chassis.
c. Release the snap at the right of the frontĆpanel module and shift the
assembly. Insert the screwdriver with a size TĆ15 Torx tip into the
right hole of the chassis, and then remove the screw securing the
monitor module.
d. Lift the monitor module up and away from the chassis to complete
the removal.