Tektronix AWG2005 Stereo System User Manual


 
AWG2005 Service Manual
xix
Introduction
This manual contains information needed to properly service the AWG2005
Arbitrary Waveform Generator, as well as general information critical to safe
and effective servicing.
To prevent personal injury or damage to the AWG2005, consider the followĆ
ing before attempting service:
H The procedures in this manual should be performed only by a qualified
service person
H Read the Safety Summary found at the beginning of this manual
H Read Preparation for Use in section 2, Operating Information
When using this manual for servicing, be sure to follow all warnings, cauĆ
tions and notes.
Generally, the internal calibration described in section 5, Adjustment ProceĆ
dures, should be done every 12 months. In addition, internal calibration is
recommended after module replacement or temperature changes.
Throughout this manual the term "module" refers to any fieldĆreplaceable
component, assembly, or part of the AWG2005.
This manual contains all the information needed for periodic maintenance of
the AWG2005. (Examples of such information are procedures for checking
performance and for readjustment.)
Further, it contains all information for corrective maintenance down to the
module level. To isolate a failure to a module, use the fault isolation proceĆ
dures found in Troubleshooting, part of section 6, Maintenance. To remove
and replace any failed module, follow the instructions in Removal and InstalĆ
lation Procedures, also part of section 6. After isolating a faulty module,
replace it with a fullyĆtested module obtained from the factory. Section 10,
Mechanical Parts List, contains part number and ordering information for all
replaceable modules.
Tektronix provides service to cover repair under warranty as well as other
services that may provide a costĆeffective answer to your service needs.
Adjustment Interval
Strategy for Servicing
Tektronix Service
Offerings