Filter
Top Products
Removal and Installation Procedures
AWG2005 Service Manual
6Ć33
Fan and Fan Frame
1. Assemble equipment and locate modules to be removed:
a. No tools are needed to do this procedure.
b. Locate the modules to be removed in the locator diagram, Internal
Modules, in Figure 6Ć4.
2. Orient instrument: Set the AWG2005 with the bottom down on the work
surface and the left side facing you.
3. Remove fan and fan frame:
a. Disconnect the ribbon interconnect cable from J3 of the power
supply module. See Figure 6Ć14.
b. As shown in Figure 6Ć14, slide (2) in the direction indicated by arrow
(1) while pushing it, and then remove the fan and fan frame.
c. Release the four hooks securing the fan, separate the fan and fan
frame.