Removal and Installation Procedures
Maintenance
6Ć38
Power Supply Module
1. Assemble equipment and locate modules to be removed: You will need a
screwdriver with a size TĆ15 Torx tip to do this procedure. Locate the
modules to be removed in the locator diagram, Internal Modules,in
Figure 6Ć4.
2. Orient instrument: Set the AWG2005 with the bottom down on the work
surface and the left side facing you.
3. Remove power supply module:
a. Disconnect the ribbon interconnect cable at J1, J3, J4, and J5 on
the power supply module. See Figure 6Ć17.
b. Disconnect the flat cable at J2 on the power supply module.
c. Using a screwdriver with a size TĆ15 Torx tip, remove the two screws
attaching the power supply module to chassis.