Removal and Installation Procedures
AWG2005 Service Manual
6Ć17
FrontĆpanel Knob
1. Assemble equipment and locate modules to be removed: You will need a
1
@
16Ć
inch hex wrench to do this procedure. Find the frontĆpanel knob on
the front panel in the locator diagram, External Modules, Figure 6Ć3.
2. Orient instrument: Set the AWG2005 with the bottom down on the work
surface and the front facing you (see Figure 6Ć5).
3. Remove front cover: If the optional front cover is installed, grasp the front
cover by the left and right edges and snap it off of the trim ring. (When
reinstalling, align and snap back on.)
4. Remove knob: Loosen the setscrew securing the knob using the
1
@
16
Ćinch
hex wrench. Pull the knob toward you to remove it.
5. Reinstallation: Place the knob onto the shaft, and tighten the setscrew
using the
1
@
16
Ćinch hex wrench.
Release
Hex Wrench,
1
@
16inch
FrontĆpanel Knob
Figure 6Ć5:ăFrontĆpanel Knob Removal