Filter
Top Products
Removal and Installation Procedures
AWG2005 Service Manual
6Ć35
Rear Shield Cover
1. Assemble equipment and locate modules to be removed:
a. You will need a screwdriver with a size TĆ15 Torx tip, a
1
/
4
Ćinch nut
driver,a5mmnutdriver and a
1
/
2
Ćinch nut driver to do this proceĆ
dure.
b. Locate the modules to be removed in the locator diagram, Internal
Modules, Figure 6Ć4.
2. Orient instrument: Set the AWG2005 with the bottom down on the work
surface and the back facing you (see Figure 6Ć15).
3. Remove rear shield cover:
a. Disconnect the ribbon interconnect cable from J30 on the A6 CPU
board. See Figure 6Ć21.
b. Using a screwdriver with a size TĆ15 Torx tip, remove the five screws
securing the rear shield cover to the chassis from the back side.
c. Using a screwdriver with a size TĆ15 Torx tip, remove the five screws
securing the rear shield cover to the chassis from the left side.
d. Using a
1
/
4
Ćinch nut driver, remove the IEEE STD 488 PORT cover by
removing the two spacer posts.
e. Grasp the serial interface connector, pull the rear shield cover toĆ
ward you taking care not to damage the cable.
f. Disconnect the interconnect cables at the CH1/CH2 MARKER OUT,
CLOCK IN/OUT and CONTROL SIG IN/OUT BNC connectors. For an
AWG2005 with Option 02, disconnect the interconnect cables at the
CH3 and CH4 MARKER OUT BNC connectors.
g. You can remove the rear panel of a slot in which no board is
mounted.
4. Remove BNC connector: Use a
1
/
2
Ćinch nut driver to remove the nut
attaching the BNC connector to the panel; then, remove the BNC conĆ
nector from the panel.
5. Remove serial interface connector: Usea5mmnutdriver to remove the
nut attaching the connector to the rear shield cover; then, remove the
connector.
6. Reinstallation:
a. Install the serial interface connector if you removed it by reversing
the items in step 5.
b. Install the BNC connector if you removed it by reversing the items in
step 4.
c. Install the rear shield cover by doing substeps 3aĆ3g in reverse
order.