Filter
Top Products
Performance Tests
Performance Verification
4Ć44
This procedure checks operation of the AWG2005 slave mode.
NOTE
This Slave Operation check has been factory verified. The check is
performed only as necessary or only after a failure.
Electrical Characteristic Checked: Auxiliary Input, CONTROL SIG IN,
Threshold level, Pulse Width, Input Volts, on pageĂ1Ć15.
Equipment Required: Two 50ĂΩ coaxial cables, a function generator, and
an oscilloscope.
Prerequisites: The AWG2005 meets the prerequisites listed on page 4Ć7.
Procedure:
1. Install test hookup and set test equipment controls:
a. Hook up master AWG2005: Connect the slave AWG2005 (device
under test) rearĆpanel CONTROL SIG IN and CLOCK IN connectors
to the master AWG2005 CONTROL SIG OUT and CLOCK OUT
connectors using the two coaxial cables.
b. Hook up oscilloscope: Connect the master AWG2005 CH1 output
and slave AWG2005 CH1 output to the oscilloscope CH1 and CH2
vertical inputs using the two coaxial cables (see Figure 4Ć20).
Slave AWG2005 (DUT)
Oscilloscope
AWG2005
Master AWG2005
AWG2005
CONTROL
SIG OUT
CLOCK
OUT
CLOCK
IN
CONTROL
SIG IN
CH1
CH2
CH1
CH1
Figure 4Ć20:ăSlave Operation Initial Test Hookup
c. Set oscilloscope controls:
Optional Check -
MasterĆSlave
Operation Check