Filter
Top Products
Removal and Installation Procedures
Maintenance
6Ć10
General Instructions
NOTE
Read these general instructions before removing a module.
First read the Summary of Procedures to understand how the procedures
are organized. Then read Equipment Required to find out the tools needed
to remove and install modules.
To remove a module, begin by doing the Access Procedure (on page 6Ć13).
By following the instructions in that procedure, you can remove the desired
module without unnecessarily removing other modules.
Summary of Procedures
The Access Procedure on page 6Ć13 identifies the procedure for removing
each module. These categories separate the procedures based on their
location in the AWG2005.
H Procedures for External Modules on page 6Ć16 describes how to remove
modules without internal access to the AWG2005.
H Procedures for Internal Modules on page 6Ć28 describes how to remove
modules which require internal access to the AWG2005.
Equipment Required
The removal of most modules in the AWG2005 requires only a screwdriver
handle mounted with a size TĆ15, Torx screwdriver tip. Use this tool whenĆ
ever a procedure step instructs you to remove or install a screw, unless a
different size screwdriver is specified in that step. The first step of a module
procedure lists all equipment required to remove and reinstall the module.