Filter
Top Products
Removal and Installation Procedures
AWG2005 Service Manual
6Ć31
Connector Module
1. Assemble equipment and locate modules to be removed:
a. You will need a screwdriver with a size TĆ9 Torx tip and a
1
@
2
Ćinch nut
driver to do this procedure.
b. Locate the modules to be removed in the locator diagram, Internal
Modules, in Figure 6Ć4.
2. Remove frontĆpanel knob: Do the FrontĆpanel Knob procedure, on
pageĂ6Ć17.
3. Remove front cover, trim ring, and menu buttons: Do the Front Cover,
Trim Ring, and Menu Buttons procedure on page 6Ć22.
4. Orient instrument: Set the AWG2005 with the top down on the work
surface and the right side facing you.
5. Remove connector module:
a. Disconnect the interconnect cables at the CH1and CH2 Waveform
Output connectors. For an AWG2005 with Option 02, disconnect the
interconnect cables at the CH3 and CH4 Waveform Output connecĆ
tors.
b. Using the screwdriver with a size TĆ9 Torx tip, remove the four
screws attaching the connector module to the chassis. See Figure
6Ć13.
6. Remove BNC connector:
a. To remove a BNC connector, remove the nut attaching the BNC
connector to the panel using a
1
@
2
Ćinch nut driver, and then remove
the BNC connector from the panel.
7. Reinstallation:
a. Install BNC connector: Do substep 6a, reversing the order of the
items in the substep.
b. Install connector module: Install the connector module by doing
substeps 5a-5b in reverse order.