Filter
Top Products
480 U41117-J-Z125-7-76
Message lines Explanation of console messages
Response
Only use cartridges with enough capacity.
SXPL056 PLM(#56): NOTICE: all PVGs of TL <name> deactivated
Meaning
This message is output after the plmcmd conf -e -T <TL> command has been issued:
All physical volume groups of the specified robot have been deactivated.
SXPL057 PLM(#57): NOTICE: all PVGs of TL <name> reactivated
Meaning
This message is output after the plmcmd conf -a -T <TL> command has been issued:
All physical volume groups of the specified robot have been reactivated.
SXPL058 PLM(#58): NOTICE: LVG <name>: Duplicating single saved LVs
Meaning
The duplication of LVs that were only saved 1x is started for the specified LVG.
SXPL059 PLM(#59): NOTICE: LVG <name>: Duplicating single saved LVs failed
Meaning
The duplication of LVs that were only saved 1x is aborted again for the specified LVG.
Bottlenecks have occurred again on the back end, e.g. library failure, failure of all physical
drives or lack of physical volumes.
Response
The bottlenecks mentioned must be cleared.
SXPL060 PLM(#60): NOTICE: LVG <name>: Duplicating single saved LVs finished
Meaning
The duplication of LVs that were only saved 1x has been completed for the specified LVG.
SXPL061 PLM(#61): NOTICE: retries exceeded on PDS <PDS-name> at unload/umount
Meaning
Despite several attempts the PLM was not able to unload the drive <PDS-name> or the
robot was not able to reset the cartridge. To avoid unnecessary robot movements the drive
is placed in the 'out of service' state (see message SXPL023 on page 475).
Response
The drive must be checked to see whether the cartridge is jammed. It may be necessary to
unload the cartridge manually. A robot fault may also be involved. In this case notify the
maintenance staff. After the fault has been cleared the drive can reset to 'in service'.