Filter
Top Products
450 U41117-J-Z125-7-76
Message lines Explanation of console messages
9.2.4 SXDN... (DNA: Distribute and Activate)
SXDN100 (DNA#100): ALERT: switch SVLP_to_VLP successfully completed! (needed time:
<mm>:<ss> (mm:ss))
Meaning
The VLP switchover was successful. The time required for it is specified in parentheses.
SXDN101 (DNA#101): ALERT: switch SVLP_to_VLP completed with errors! (needed time:
<mm>:<ss> (mm:ss))
Meaning
The VLP switchover has been completed. The previous SVLP is now the current VLP. Ho-
wever, errors occurred when the system was started. The details can be found in the Bro-
ker’s logging files (/usr/apc/broker/broker.log). The time which was required for re-
configuration is specified in parentheses.
Response
The cause of the error must be removed. After this, the configuration function Distribute and
Activate must be initiated in Reactivate_failed_config mode.
SXDN102 (DNA#102): ALERT: switch VLP_to_SVLP successfully completed!
The VLP has been successfully reconfigured as the SVLP. This message is output only if
the reconfiguration was triggered by the VLP function Swap Master.
9.2.5 SXDT... (DTV File System)
SXDT001 DTV(# 1): ALERT: resource allocation failed, interface not activated!
Meaning
It was not possible to allocate the necessary resources for the DTV file systems. As a result,
the TFS/DTV file systems cannot be mounted.
Response
Notify maintenance staff.
SXDT002 DTV(# 2): ERROR: unmount(<maj,min>): filesystem state not clean!
Meaning
The specified file system has been unmounted, even though it was not possible to perform
all I/O operations on the metadata successfully. As a result, the file system on the corre-
sponding hard disk is inconsistent.
Response
Notify maintenance staff.