Filter
Top Products
U41117-J-Z125-7-76 111
Operating and monitoring CentricStor Starting GXCC
Starting GXCC with the “Remote Program Starter”
Ideally, GXCC should be activated via the “Remote Program Starter”. This allows the
process to be automated such that GXCC can be started by clicking an icon. When GXCC
is started in Observe mode, no further dialog is then required.
Preparing the Program Starter:
An appropriate file (*.rps file) must be created. The characteristics must be set in accor-
dance with the following example:
Host
Specify the host on which GXCC is to run. If this host is not part of CentricStor, an
additional host parameter must be specified in the command line to start GXCC.
Command line
The command line, which is only partially visible in the editing area of the sample
screen, first starts a terminal emulation. Emulations of 97801-480 or VT420 terminals
are recommended (as in the example).
The path specification must be absolute. The parameters visible in the screenshot
relate to the alphanumeric terminal and serve as an example only.
-sb Scrollbar
-ls Login shell
-j Jump scroll
-sl <no.> Size of scroll area
-name <text> Label of upper window margin
-display <IP address or hostname>:<digit>.<digit>
Address of the host running XVision: screen showing the
display.
-e <command line> This command line, which should be executed following login, is
used to start GXCC. The line should not contain a “-display”
specification. The closing “&” can be omitted.
All entries after “-e” belong to this command line. Options for
terminal emulation must therefore be entered before “-e”.