Filter
Top Products
AW1600 Owner’s Manual
Using the locator
7
Various types of playback
66
The following procedure shows how to register the current
location in one of the locate points, and then move the
song to that locate point.
1
Move the song to the point that you want to
register as a locate point.
You can set a locate point whether the song is playing
or stopped.
2
Hold down the [SET] key and press the key
for the desired locate point.
The locate points correspond to the following keys.
• [IN] key.......................In point
• [OUT] key...................Out point
• [A] key........................A point
• [B] key........................B point
•RTZ [ ] key ............Relative Zero point
3
To move to a locate point you registered,
press the corresponding key while the song
is stopped or playing.
The song will move to that location, and an icon will
appear at the left side of the counter to indicate the
currently selected locate point.
This icon will remain visible until you play or rewind/
fast-forward past the previous or next locate point or
marker location.
Locate points that you register are displayed in the
TRACK screen VIEW page or PAD page as shown
below.
In point
A point
Relative
Zero point
B point
Out point
• If you want to change the Start point or End point, use the
SONG screen POINT page. These points cannot be set by
key operations.
• The In point and Out point will be updated automatically when
you perform a recording operation.
NOTE
Locator icon
Locator icon
• Locate point settings are stored on the hard disk as part of
the song.
• Locate points can be adjusted as desired (
→
p. 68). Locate
points other than the Start point and End point may also be
erased (
→
p. 69).
HINT