Filter
Top Products
AW1600 Owner’s Manual
Basic operation on the AW1600
2
Introducing the AW1600
26
You can use the knobs and keys of the Selected Channel
section to directly operate the mix parameters (EQ,
dynamics, pan, etc.) of the currently selected channel.
1
Use the [TRACK SEL] keys, [INPUT SEL]
keys, [STEREO SEL] keys, or pads 1–4 to
select the channel that you want to operate.
When using the
Selected Channel
section, you must
first select the chan-
nel that you want to
operate. The currently selected channel is indicated in
the upper left of the screen.
The channels correspond to each key or pad as fol-
lows.
• [TRACK SEL] keys 1–8 ....Track channels 1–8
• [TRACK SEL]
keys 9/10–15/16................Track channels
9/10–15/16
• [INPUT SEL] keys 1–8......Input channels 1–8
• [STEREO SEL] key...........Stereo output channel
•Pads 1–4............................Pad channels 1–4
2
According to the parameter you want to
edit, turn the five knobs of the Selected
Channel section.
The following items will change when you turn each
knob.
3
If you want to access the screen for a
parameter and edit it in greater detail, press
one of the five knobs or the [VIEW] button.
Pressing each knob or button will access the following
screens.
● EQ screen EDIT page
4
Move the cursor in the screen to the
desired parameter, and use the [DATA/JOG]
dial or the [ENTER] key to operate the
parameter.
Using the Selected Channel section
Turn the [EQ] knob
This changes the amount of boost/cut for the selected EQ
band. To select the EQ band, use the [HIGH], [HI-MID],
[LO-MID], and [LOW] keys located at the right.
Turn the [DYN] knob
This changes the depth of
dynamics processing.
Turn the [EFFECT 1] knob
This adjusts the level of the
signal that is sent from that
channel to internal effect 1.
(If the stereo output channel
is selected, this adjusts the
return level from internal
effect 1.)
Turn the [EFFECT 2] knob
This adjusts the level of the
signal that is sent from that
channel to internal effect 2.
(If the stereo output channel
is selected, this adjusts the
return level from internal
effect 2.)
Turn the [PAN/BAL] knob
This adjusts the pan of the signal that is sent from that channel
to the stereo bus. (If the stereo output channel is selected, this
adjusts the balance of the left and right channels.)
• Simply turning the knobs of the Selected Channel section will
not cause the screen to change.
• If you turn the [DYN] knob immediately after recalling a preset
library that includes dynamics settings, multiple dynamics
parameters will change simultaneously, affecting the way in
which dynamics processing is applied. The depth of this
change will depend on the library that is recalled.
NOTE
Press the [EQ] knob
The EQ screen will appear.
Press the [DYN] knob
The DYN screen will appear.
Press the [EFFECT 1] knob
The EFF 1 screen will appear.
Press the [EFFECT 2] knob
The EFF 2 screen will appear.
Press the [PAN/BAL] knob
The PAN screen will appear.
Press the [VIEW] key
The VIEW screen will appear.
• If you change individual parameters in the DYN screen, the
parameter that you operate last will be assigned to the [DYN]
knob.
• If you want to return to the state in which turning the [DYN]
knob will adjust multiple parameters simultaneously, you must
once again recall the library containing the dynamics settings
you recalled prior to editing in the DYN screen.
NOTE