Filter
Top Products
Using the test tone oscillator
14
MIDI and utility functions
167
AW1600 Owner’s Manual
The OSC page of the UTILITY screen lets you send the signal of the AW1600’s built-in test oscil-
lator (the test tone oscillator) to the desired bus.
To access this page, repeatedly press the Work Navigate
section [UTILITY] key or hold down the [UTILITY] key
and use the CURSOR [ ]/[ ] keys.
This page contains the following items.
1 WAVEFORM
Selects one of the following signals for output from the
oscillator.
• OFF button.......................Oscillator is off
• 100Hz button ...................100 Hz sine wave
• 440Hz button ...................440 Hz sine wave
• 1kHz button .....................1 kHz sine wave
• 10 kHz button ..................10 kHz sine wave
• NOISE button...................White noise
When you turn on a button, the oscillator output will
immediately be sent to the specified bus. Use the
3–6
buttons to specify the bus to which the signal will be sent.
B LEVEL knob
Adjusts the output level of the oscillator.
C AUX 1/2 buttons
Send the oscillator output to AUX buses 1/2.
D EFF 1/2 buttons
Send the oscillator output to effect buses 1/2.
E BUS L R button
Sends the oscillator output to the L/R bus.
F ST L R button
Sends the oscillator output to the stereo bus.
G Level meter
Indicates the output level of AUX 1/2, effect bus 1/2, and
the L/R bus.
Using the test tone oscillator
1 34
76 5
2
• If the LEVEL knob is raised when you output the oscillator signal,
a high volume level may be produced suddenly. Be sure to lower
the LEVEL knob before you switch on the oscillator.
HINT
• Sine waves and white noise have a higher sound pressure than
they perceptually appear. These signals may damage your speak-
ers if played at a high volume, so please use caution.
NOTE