AW1600 Owner’s Manual
Digital input settings and Initializing the internal hard disk
14
MIDI and utility functions
168
In the D.IN HDD page of the UTILITY screen you can make settings for digital input, and initialize
the internal hard disk.
To access this page, repeatedly press the Work Navigation
section [UTILITY] key or hold down the [UTILITY] key
and use the CURSOR [ ]/[ ] keys.
This page contains the following items.
1 DIGITAL IN PATCH
Selects one of the following as the destination to which
the signal from the DIGITAL IN jack will be sent.
• DISABLE ................The DIGITAL STEREO IN jack will
be disabled.
• INPUT 1/2–7/8........ The signal will be sent to input
channels 1/2–7/8. If you select this
setting, the MIC/LINE input jacks
for the corresponding input chan-
nels will be disabled.
• STEREO BUS.........The signal will be sent to the ste-
reo bus.
B ATT knob
Adjusts the level of the signal that is sent from the DIGI-
TAL STEREO IN jack to the stereo bus.
C DIGITAL REC ON/OFF button
Enables (ON) or disables (OFF) digital recording from the
DIGITAL IN jack, and importing of digital audio data
from an audio CD or WAV file inserted in the CD-RW
drive.
When you switch this setting ON, the following message
will be displayed.
OBSERVE Copyright Notice
Written in Owner’s Manual?
[Cancel] [OK]
If you agree to the conditions described in “Copyright
Notice” (→ p. 6), select [OK]. When you select [OK],
recording and importing of digital audio data will be
enabled.
D VARI PITCH ON/OFF button
Selects whether the sampling frequency will be adjustable
(Vari-pitch function) when DIGITAL IN PATCH is set to
DISABLE. If you turn this button on, vari-pitch will be
enabled, and you can use the VARI PITCH knob to adjust
the sampling frequency.
E VARI PITCH knob
Adjusts the sampling frequency of the current song in a
range of –5.97 to +6.00%.
Digital input settings and Initializing the internal hard disk
1 4 6
G532
• If you select DISABLE, the AW1600 will operate using its own
internal clock. If you select any other setting, the AW1600 will syn-
chronize to the clock contained in the input signal from the DIGI-
TAL STEREO IN jack. However when playing an audio CD, the
AW1600 always operates using its own clock.
HINT
•You cannot switch this setting while the recorder is running.
• If you select a setting other than DISABLE, a message of
“((((WRONG WORD CLOCK!!))))” will be displayed if appropriate
clock data is not being sent to the DIGITAL STEREO IN jack.
While this message is displayed, all channels will be muted and
the recorder section will not operate. To make the AW1600 oper-
ate, you must either input the correct clock signal or switch the
DIGITAL IN PATCH setting to DISABLE.
NOTE
• The ATT knob is meaningful only if DIGITAL IN PATCH is set to
STEREO BUS.
HINT
• The DIGITAL REC ON/OFF button is always set to OFF when you
turn on the power.
HINT
•Vari-pitch is not available if DIGITAL IN PATCH is set to other than
DISABLE, or if you have selected MTC Slave in the MIDI 2 page of
the UTILITY screen.
NOTE